Saturday was a pleasant sunny day and with band conditions being in such good shape, I decided to do a few hours operating. Again, using the end fed half wave on 10m and 12m. Signals were good and it was easy to work the USA, United Arab Emirates, Puerto Rico, Madagascar, Canada, and Guatemala on 28MHz with a simple setup and 100w. Once the sun got a bit low, it did get a bit chilly though!
28MHz has been in good shape recently, so I wanted to go out portable and try my end fed half wave parallel tuned circuit coupler as I have not tried it on 10m before. The band was in good shape (unlike the weather) and it seemed to work well. I managed to work some good DX whilst I was there, the log can be seen below.
I also took a little video of me working VA3AQB – Alan in Canada. The coupler seemed to work well on 10m and with a bit more bandwidth than other bands, perhaps because very little capacitance was needed. I’m enjoying making the most of the higher bands whilst they are open! John.
We went out for some portable operating today, as the weather was nice. Our club has a topband net each Saturday at 2pm and I wanted to try an antenna for the upcoming 160m AFS Club Calls contest. Using Dave M0TAZ’s 18m spiderbeam fibreglass pole as a loaded quarter wave, with an inductor (340μH) towards the top of the antenna. It makes it all a bit critical having the inductor so high, but the big advantage is that the bottom 15.5 metres has a lot of current in it, leaving only the 2.5 metres above it at a high impedance, making a better radiator. Ground was provided by a chicken wire fence, which I have used many times before with good results.
Below is a short video showing the antenna first on 24MHz where Dave is working Bahrain where the vertical was set up close to a ⅝ wave, then afterwards, it’s fully extended with the loading coil 15.5 metres up, making it a loaded ¼ wave for 160m. The antenna was resonant at 1830kHz, a bit low, so the ATU was used. I calculated for 1900kHz, so I guess 70kHz off isn’t bad! It would be easy enough to fine tune it. Lovely day for it, a bit breezy towards the end though!
I was operating portable on 12m (21MHz) today. It’s a band which I have hardly ever used, so I cut a half wave length of wire and used my End Fed Half Wave Coupler to match it at the base of the fibreglass pole. Conditions seemed good and I was able to work Chicago, Massachusetts, California, New York and Texas in a short time. Below is a short video and photo of the setup.
Our club operated in the CQ World Wide contest this year. We had 2 main stations running, one on 20m and the other on 15m. Some QSO’s were had on other bands too. Together, we totalled 1743 contacts. I also worked 50 from home in about an hour on 15m. More info and photos from our clubs activity can be seen here. Below is a pic of me operating the 15m station. Oh, and I shaved the beard off
The FT-897D is a very efficient transceiver for portable use, perhaps because it is designed for use with battery power in mind. As I recently purchased an Icom IC-7200 to replace it for HF use whilst portable, I thought I would do some tests on the efficiency of them both, and also my FTDX1200 for comparison. The IC-7200 is comparable to most other HF desktop transceivers, using up to 20A with a 100W carrier.